does anyone over here make/sell centre consoles for a sq back?

got to connect my heat exchangers to the chassis tomorrow, ive a 68 sq back what levers/knobs to what? there are the 2 levers either side of the handbrake and 2 round knobs on the dash also there are some plastic things up under the dash, what do they do?shold there be anything else under the dash? ...

the old carbs had electronic chokes , but the webbers do not , i wasnt sure if they were activated by depressing the pedal , like in old fords??
jamie

had engine set up on car before it went to the paintshop it had its standard carbs removed and some 34's put on, i picked it up yesterday and it started semi ok , but the shop had had it running, tried it today and its like it has no choke , once its warm its sound , they were electronic before , is...

sound mate what ya want for it?
jamie

does anyone have/stock the material stuff that goes around the side windows ona squareback , simular to headlinner but without the perforated holes
cheers
jamie

ive just bought a 68 square with 914 alloy 2 litre wheels , what should be holding them to the hubs nuts or bolts?as it has both?? should it have alloy nuts?

who stocks squareback window rubber over here???in desperate need of rear side windows.......
j

how are door seals supposed to be attatched? im asuming its not with silicone!!

pillar now sorted , and ready for new paint.....

wheres the switch over point from early to late?
cheers
jamie

its black trim im looking for, the car is lotus white, and is being sent to the painters next week so some new trim would be nice as i think the stuff in there is original, the rear side window rubbers are fu£$ed split cracked and dropping apart , so they are of upmost importance ,

dont anyone stock wcm trim over here??

also the front /rear wing rubber gasket , is that the same as a beetle? do you just buy it by the metre or is it pre cut?

i ment the engine cover seal that goes on the floor of the car around the hole for the engine

also need the petrol filler rubber and that 90 degree hose breather,

who would stock engine lid trim? anlso need rear side window rubbers/trim for a squareback ,

sorry for being a little dumb, hadnt herd of woolies trim........

WOOLIES??? aint they gone bust......

who stocks the plastic grommets that push into the doors etc for the panels , and the clips that fix to the panels, i know wcm do them but who over here stocks all this little stuff??
cheers
jamie

ive just removed my standard airbox n carbs and replaced with twin 34's and pancake filters , what now has to happen to the oil breather that went to the air/oil box??
cheers
jamie

aint anyone stocking these things over here?

whats the jetting/mixture on these carbs for a 16-- variant standard pipe (its a 68 motor with later type 4 pipe i think?
cheers
jamie
whats the settings for mixture etc??

is it possible to move an a pillar back 5mm? as i think motor at some point in life has had a knock as the door alinement aint quite right , is there a chosen method for this job?

are these 3 point or just lap?