Good evening all - so I've been routing around the engine bay whilst sorting out a heater problem and noticed something that looked out of place, some copper pipe. I'm not much of a mechanic so just wondered if someone could tell me what the copper pipe does.
TIA Paul
Engine part identification
- purplepeter
- Posts: 2339
- Joined: 8th August 2006 - 4:41pm
- Location: Bath, Avon
Re: Engine part identification
It's a bodged up Breather
Normally You'd have a rectangular black box there with a hose to recirculate vapour through the air cleaner
#29 on this diagram http://www.hallvw.clara.co.uk/type3/T3pbo/T3pb1-60.htm
Presumably whoever fitted the carbs would have done it
Normally You'd have a rectangular black box there with a hose to recirculate vapour through the air cleaner
#29 on this diagram http://www.hallvw.clara.co.uk/type3/T3pbo/T3pb1-60.htm
Presumably whoever fitted the carbs would have done it
Re: Engine part identification
PP - many thanks for the explanation. Now if i'd had done it that would have been a bodge, but as is I think it's a tidy alternative
Any downsides from original? I think the carbs were fitted when it was imported to the UK as I assume it was originally FI, which may explain why there's no choke.
Any downsides from original? I think the carbs were fitted when it was imported to the UK as I assume it was originally FI, which may explain why there's no choke.
- purplepeter
- Posts: 2339
- Joined: 8th August 2006 - 4:41pm
- Location: Bath, Avon
Re: Engine part identification
The original had provision for relief of excess crankcase pressure, which Yours doesn't, but it'd be a lot of work/effort to reinstate one (an afternoon of your time) Personally, I prefer stock anyway.
I would query where that aluminium ducting pipe on rhs of fanhousing goes to, as it's normal to blank off the air outlets when fitting an aftermarket exhaust
There is a complete breather listed in the for sale section on behalf of a former type 3 owner who's Emigrating
I would query where that aluminium ducting pipe on rhs of fanhousing goes to, as it's normal to blank off the air outlets when fitting an aftermarket exhaust
There is a complete breather listed in the for sale section on behalf of a former type 3 owner who's Emigrating