Just for 411 and 412 stuff.
-
cookie
- Posts: 20
- Joined: 13th February 2008 - 12:42am
- Location: Birmingham
Post
by cookie » 12th September 2009 - 12:14am
the rubber boot on the slave cylinder has split on my 75, 412, can u get a rebuild kit ?, it is a real big slave cylinder not your normal t4 or t2 one
-
kps70
- Posts: 375
- Joined: 24th April 2007 - 7:40pm
- Location: Malawi
Post
by kps70 » 17th September 2009 - 7:44pm
Are you talking about the clutch slave cylinder?
Kieron
-
shawn71
- Posts: 1060
- Joined: 14th November 2007 - 11:54am
- Location: East Sussex
Post
by shawn71 » 17th September 2009 - 8:40pm
If so try Volksfarmers as they might have a spare knocking around somewhere (they did for me anyway) or Brian might know of a boot that would fit.
-
kps70
- Posts: 375
- Joined: 24th April 2007 - 7:40pm
- Location: Malawi
Post
by kps70 » 18th September 2009 - 5:15pm
I'll have a look in my shed too!
Kieron
-
kps70
- Posts: 375
- Joined: 24th April 2007 - 7:40pm
- Location: Malawi
Post
by kps70 » 20th September 2009 - 4:42pm
Think I have what you need? It seems to be part of a repair kit with large rubber boot and large rubber seal. I got it from the states but since then have located two NOS slave cylinders so I don't need the repair kit really. The number on the box is 411798041 although this may be the wrong box. On the boot is the number FAG K4450 and 1-25. Here's a picture.
Kieron
-
Editor
- Posts: 5515
- Joined: 10th October 2004 - 8:52pm
- Location: Pensford, Bristol
-
Contact:
Post
by Editor » 20th September 2009 - 5:07pm
That number is for the repair kit for the clutch slave cylinder up to '69 models. I don't know if any of it will fit the later ones, or if yours is actually an early one anyway, or if it would work.
It may be the right kit, just the wrong number, of course!
Dave.
-
Jane Terry
- Posts: 75
- Joined: 27th May 2005 - 9:57pm
Post
by Jane Terry » 6th October 2009 - 1:27pm
looking at the kit pieces it is for the 411L as it has a small diameter cylinder compared to the later one.