I have a 1641 twin port Type 3 engine. The short block was rebuilt by a local engine builder/drag racer. Unfortunately I found stowaways in the shed. A pair of robins decided it would make a good nest site. I've cleaned it out but I think it needs stripping back and reassembly. It's been built back up to a full engine. The engine bar is off as it wasn't going back in a type 3. There are carbs but they need a rebuild. Choice of J tubes or untested heat exchangers. Non standard exhaust. It's a universal case.. I'm looking for £800 ono. I know a courier that will transport at your cost.
I also have a stripped engine, short block, with heads and tinwear that was a running engine. I've probably got all the bits for this as well. £500 ono.
I've also got other type 3 parts.
Please say whether for Type 3 or Type 4
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest